Back to Emu8086 home or the install guide. If the problem turns out to be in your code rather than in the program itself, the 8086 instruction set and opcode reference may help you check the instruction you are using.
Runtime and permission errors usually appear when Emu8086 tries to do something Windows will not let it do — read a file, write a file, or use a folder it does not have access to. The error message may be vague, so start with the locations and permissions involved, not with reinstalling.
What you may see
- An error when opening, saving, or compiling a file.
- A message about access being denied.
- Emu8086 working for one file but failing for another in a different folder.
A likely cause, stated carefully
A likely cause is that the program, or the folder holding your files, does not have the access it needs. This is common with folders under Program Files and with files copied from another computer, but it is not certain in every case — work through the checks below to narrow it down.
Steps to try
- Check where your files live. Move your source files to a folder you control, such as Documents, and try opening them from there. If they work there but not in the original folder, the folder was the problem.
- Try running as administrator. Right-click the program and choose Run as administrator, then repeat the step that failed. If it now works, you have a permission problem rather than a broken file.
- Check the program folder too. If Emu8086 itself is installed in a protected folder, it may not be able to write its own working files. Try moving the program folder to a location you control, as described in our guide to Program Files write problems.
- Check the file itself. Make sure the file is not marked read-only, is not still open in another program, and is not stored on a drive that is disconnected or out of space.
- Try a copy, not the original. Copy the file to a new folder and try the copy. If the copy works, the original location or its permissions were likely the issue.
What to check next if it still does not work
If the error follows one particular file to every folder, the file itself may be the problem — try a small test program instead. If Emu8086 closes with no message at all, see our guide to silent crashes on launch. If the message mentions a path with characters outside basic English letters, also see problems with non-English paths and fonts.
Once it runs, see the tutorials linked from the home page to continue.
